SK 360 set up

Last night, I finished the mechanical modification and basic software set up tonight I am going to finish the rest prior to take off.

To remind myself .... every change must be saved into the gyro by pressing "F1" on the key board.
_________________________________________________________________



push the pitch stick to mid point and keep it there, check "input from receiver" area, then change the values in (Trim %) to make the "input from receiver" as close to zero as possible, do the same on elevator and aileron by pushing nose up/tail down and aileron right position



________________________________________________________________





push the pitch to max, if the box is red in color, check or uncheck the relevant box in "reserve" to change it to green




___________________________________________________________________
If the swashplate moves in wrong direction, change the sign in swash mixing as you would do in the transmitter to change this.

This swash mixing is same as the one in transmitter but best to keep value below 60.





_________________________________________________________________




Now, push the Elevator to tail down/nose up position and Aileron right to set up as the pitch stick




____________________________________________________________________





Check the "input from receiver", change the value in Travel % to achieve 100% at max pitch, nose up/tail down and aileron right position





____________________________________________________________________




Since I installed the gyro with VR dials towards the tail, I checked the "Rotate 90 Degrees" box, same thing when the VR dials facing the nose, if else, the box should be unchecked.



____________________________________________________________________





now it is time to set the sensor direction, I picked up the heli and tilt the nose up, the sensor box should be green, if red then, change the "flip elevator Axis". then tilt the heli right and do the same


______________________________________________________________

That was not even half an hour, the whole process is really self-explanatory, but I am a chicken ... I saved the set up into a file then unplug the USB. To be surely safe, I put the gyro back in flight mode, replug the battery and tilt the heli around.

Seeing the swash plate keeps leveling itself to the horizon, that looks like I set up the gyro right.

Now, all I need to do is wait for a flight test ...... seems there is typhoon coming and will rain cats and dogs over the weekend, I may need to wait for a while